Vehicle Standard (Australian Design Rule 19/0019/00 – Installation of Lighting and Light-Signalling Devices on L-Group VehiclesInstallation of Lighting and Light-Signalling Devices on L-Group Vehicles) 20062006 Amendment 11

I, JAMES ERIC LLOYD, Minister for Local Government, Territories and Roads, determine this vehicle standard under subsection 7 (1) of the Motor Vehicle Standards Act 1989.

Dated  5 December 2006

[SIGNED]

James Eric Lloyd

Minister for Local Government, Territories and Roads

CONTENTS

1. legislative provisions..............................................

2. amendment of vehicle standard......................................

Schedule 1.............................................................

1. legislative provisions
   1.                                  Name of Legislative Instrument
      1.                            This instrument is the Vehicle Standard (Australian Design Rule 19/00 – Installation of Lighting and Light-Signalling Devices on L-Group Vehicles) 2006 Amendment 1.
   2.                                  Commencement
      1.                            This instrument commences on the day after it is registered.
2. amendment of vehicle standard
   1.                                  The changes specified in Schedule 1 amend Vehicle Standard (Australian Design Rule 19/00 – Installation of Lighting and Light-Signalling Devices on L-Group Vehicles) 2006.

Schedule 1

[1]               Purpose and Scope, replace “moor” with “motor”.

[2]               Clause 19.6.101.3, replace “poston” with “position”.

[3]               Annex A, clause 19.6.1.5, amend to read ”For ‘LB2’ and ‘LE2’ category vehicles, the lamp may not move with the steering.”

[4]               Annex A, clause 19.6.2.1.4, amend to read “in the case of ’LB2’ category vehicles, 2 lamps to either ADR 54/... or ECE R 76/00.”